Peopoly started out as a personal project between 2 friends enjoy building 3D printers in 2015. We built a few FDM 3D printer based on RepRap, Ultimaker and other open source designs and enjoyed the experience. While we learned a lot from experience and created several useful printers, we weren't satisfied with the low resolution from the FDM results.

Leave a Comment

Time limit is exhausted. Please reload the CAPTCHA.

Close Popup
Privacy Settings saved!
Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

Technical Cookies
In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec_
  • wp-settings-
  • wp-settings-time-

Decline all Services
Accept all Services